MIDI2600: Assembly Notes

Note: All MIDI2600 boards purchased from highlyliquid.com are now fully assembled before shipment.

This kit contains some ESD-sensitive parts. Please take reasonable static-control precautions when assembling the kit.

The location of each part is clearly marked on the MIDI2600 circuit board.

All components are mounted on the side of the board with the white legend. Components can be mounted in any order, but it is easier to mount the smallest components first.

Part	Image*	Notes
C1-C3		None.
C4		This part is not required.
D1-D17		Dark band on diode must match the white band on the circuit board legend.
IC1		Mount socket on the circuit board first, then insert IC into socket. Notched end must match notch in the circuit board legend.
IC2		Mount socket on the circuit board first, then insert IC into socket. End marked with dot must match notch in the circuit board legend.
LED1-LED2		Short lead on LED must match the flat side on the circuit board legend.
R1		220Ω resistor, marked with the following color bands: red, red, brown, gold.
R2-R5		4.7kΩ resistor, marked with the following color bands: yellow, violet, red, gold.
R6-R7		1kΩ resistor, marked with the following color bands: brown, black, red, gold.
R8		10kΩ resistor, marked with the following color bands: brown, black, orange, gold.
SW1		Numbers on switch should match numbers on circuit board legend.

*Appearance of parts may vary.